We all know the good applicability of enamel reactor, and we also know about which materials will form corrosion condition to the enamel layer of enamel reactor, so in addition to hard materials, what other materials are the formation of enamel reactor damage? Here is an introduction for us.
1, enamel reactor to prevent mixing of materials will have bubbles. In the actual process operation, such as: in enamel reactor agitator blade adjacent to the feeding tube and gas injection, in the pot when the boiling point or near the boiling point of the material mixing materials; In the reaction of low-level materials such as stirring, the reaction of the material will occur a lot of bubbles, then these bubbles will be enamel reactor layer damage occurred.
2, enamel reactor to prevent the mixing of materials with suspended matter. General suspension and enamel reactor layer will have a fierce conflict, at the same time the suspension itself will have a conflict, in the state of material constantly stirring and conflict, the interior of the enamel reactor was greatly worn, and a lot of electrostatic charge was accumulated. Some materials recorded that the sparks of these electrostatic charges could be as long as several centimeters in the air, such a high electrostatic charge on the enamel reactor layer will occur pinhole perforation, and when the number of feeding times, these holes will be more and more, resulting in enamel reactor damage.
So we usually not only care about the material into the enamel reactor equipment, about the material into the tank, what will happen in the mixing process, also need to raise our attention. Therefore, in order to improve the service life of the equipment, it is necessary to observe the use of the reactor process.